Installing Windows multiple times on different disks
Remark 1: Please make sure that you know the installation limits of all involved operating systems.
Remark 2: The disk parameters "number of heads" and "sectors per track" must not change between installation of an operating system and
the later usage. The simplest solution is to configure in the BIOS all disks to have
255 heads and 63 sectors per track.
In order to install DOS and Windows 95/98/ME/NT/2000/XP/2003/Vista/2008/7/8/10 multiple times on different disks the following
procedure should be employed:
- DOS or Windows is installed on the first disk.
- A physical second disk must appear temporarily as the first disk. This can be achieved, for example,
by deactivating temporarily the physical first disk (detach the data cable).
- On this physical second disk (now appearing as first disk) DOS or Windows can be
installed without problems.
- The physical first disk is re-activated. Both disks are now available as before.
- Windows on the first disk is booted (without support of Boot-US).
- The configuration program Boot-US is started and the desired partitions on the first and second disk
are included in the boot manager. Again "automatic hiding of partitions"
must be activated.
- By the boot manager Boot-US all partitions on the first and second
disk can be booted. The selected partition will be made visible while the other non-selected
primary partitions will be hid during the boot process.
If Windows 2000/XP/2003/Vista/2008/7/8/10 is involved you must true hide all partitions, see Windows tip 5.